![]() I’m installing onto a solid state drive and I do have a Santa to USB connector so I can easily connect the drive to my MacBook error and mount the EFI partition if I need to so if anyone could help me maybe figure out this last step I think I’m good to go and I can handle the rest I just need to get to that second part of the installation so it can finish properly without giving me the failed message with the only option to restart and try again. ![]() Hi all, so I get the installer made and boot up and go ahead and go through the first install process formatting the drive etcetera Etc and then when it reboots to go into the second phase to do the clean install it gets almost all the way done and then gives me an error message with no specifics just failed to initialize properly or something like that and my only option is to restart so I go back into the boot disk and find out that even though I formatted hfsplus the High Sierra installer converted it to a PFS so my question is, is this why my install keeps failing and do I need to add the a PFS file or text to my EFI volume on the new boot disk? Or do I use Clover to configure it differently or add it in there? I think this is the only thing holding me up at this point but I’m not sure what to do or how to do it so if someone could explain that part to me I would be ever so grateful. I have celeron procesdor with 4GB ram can i install high sierra? I’m actually formatting the install on this tower to then install the drive into an old HP Compaq I picked up on the cheap. I tried turning off my overclock and running the suggested settings shown in the guide but no changes. I have a Gigabyte Z270 Gaming 7 with a 7700K. But then it just hangs up right there and never does anything showing 1% or so on the bar. Then I see the apple logo, then the logo with the the progress bar. ![]() Then selected the option to boot the installer. I booted from the mac, got to the clover menu. Hi, I’m trying to boot from the usb installer I created using TransMac. You can check the system specifications down below. We’ve installed macOS High Sierra on Gigabyte Z270N WiFi Motherboard. Install macOS High Sierra on PC -Hackintosh 2018 Note: This guide is mainly for GIGABYTE systems, and some supported Intel Based systems. That’s the reason some volunteer developers try hard to create some tools and application to use them and building a Hackintosh PC with a minimal budget. It’s costly to buy an iMac or MacBook device, and most people can’t afford it. Creating a Hackintosh PC these days became an excellent topic for none Apple users. There are hundreds of Videos and posts on the internet, but in this guide, you’ll learn all the steps with screenshots and easy wording sentences. You can now quit Terminal and eject the volume.In this article, I’m going to show you the step by step guide to install macOS High Sierra on PC. When Terminal says that it's done, the volume will have the same name as the installer you downloaded, such as Install macOS Ventura.After the volume is erased, you may see an alert that Terminal would like to access files on a removable volume.Terminal shows the progress as the volume is erased. When prompted, type Y to confirm that you want to erase the volume, then press Return.Terminal doesn't show any characters as you type. When prompted, type your administrator password.If the volume has a different name, replace MyVolume in the command with the name of your volume. Each command assumes that the installer is in your Applications folder, and MyVolume is the name of the USB flash drive or other volume you're using. Type or paste one of the commands below into Terminal, then press Return to enter the command.Open Terminal, which is in the Utilities folder of your Applications folder.Plug in the USB flash drive or other volume that you're using for the bootable installer.
0 Comments
Leave a Reply. |